How to solve the intermittent flameout problem of Caterpillar excavator 3126B diesel engine and C-9 diesel engine
12.2021 Caterpillar ECM ECU Flash Files Full Set Download
1. Cause of failure
(1) There are certain fault codes or event fault codes that prevent the diesel engine from starting.
(2) There is a problem with the ECM connector and speed/timing sensor connector.
(3) The circuit breaker trips.
(4) The speed/timing sensor is misaligned.
(5) The fuel system is faulty.
(6) The fuel injector does not work.
2023 CAT ET 2023A 2023C & 2019C Full Service Download and Installation Service
2. Troubleshooting
(1) Connect ET and check whether there are current fault codes and/or historical fault codes. Before
continuing with this procedure, troubleshoot and troubleshoot existing fault codes. When a fault code
exists, the diesel engine will not start.
(2) Check whether ECM connector J1/P1, connector J2/P2, connector J3/P3 and speed/timing sensor
connector are installed correctly.
(3) Check the battery wires from the back of the ECM to the battery compartment, check the wires and
power relay, and check the power and ground wires of the ECM. Please refer to Section 11.5 of this
chapter.
Caterpillar CAT Factory Password Calculator Generator 10 Digits VM Version
(4) Check the circuit breaker. When overheating, circuit breakers may trip. If the circuit breaker trips,
reset the circuit breaker.
(5) After installing the new ECM, the speed/timing sensor should be calibrated.
(6) Check the fuel system.
