this article mainly introduces Caterpillar 311F LRR - JFT Crawler Excavator Engine Camshaft bearing Removal and Installation
Camshaft bearing-Removing and installation
Caterpillar ET 2024A & 2023C & 2019C Electronic Technician Diagnostic Software Download and Installation
Removing steps
A . Remove the camshaft. For the correct steps, see Disassembly and Assembly, "AC Camshaft-Removing and Installation".
pay attention to
Keep all the parts clean without impurities.
Impurities can cause rapid wear and shorten component life.
1. Check the camshaft bearings (1). For more information, see the technical parameters, "Camshaft bearing".
2. If the camshaft bearing (1) is worn or damaged, use tool (A), and tool (B) to remove the camshaft bearing from the cylinder block.
Note: Remove the camshaft bearing from the front of the cylinder block.
Installation steps
Caterpillar 18 Digits Factory Password Calculator One-Time Calculate Service
pay attention to
Keep all the parts clean without impurities.
Impurities can cause rapid wear and shorten component life.
1. Clean the bearing housing in the cylinder block. Ensure that there is no debris in the oil hole of the bearing housing.
2. Lubrbe the bearing housing in the cylinder block with a clean engine oil.
3. Accurately align the large oil hole (X) on the camshaft bearing (1) with the one on the cylinder block.
4. Use tools (A) and tool (B) to install the camshaft bearing (1) into the cylinder block.
Note: Ensure that all oil holes are properly aligned. If the oil hole is not properly aligned, remove the camshaft bearing.
End By: Install the camshaft. For the correct steps, see Disassembly and Assembly, "AC Camshaft-Removing and Installation".
CAT Caterpillar ET 3 Diagnostic Adapter 317-7485/478-0235 Diagnostic Tool-high quality
