Translate

2024年2月4日星期日

How to Disassemble the Rotary Reduction Device of Caterpillar 325, 320L, 320N, and 320S Excavators

 This article mainly introduces the rotary reduction device of Carter 325, 320L, 320N, and 320S excavators. 

 12.2021 Caterpillar ECM ECU Flash Files Full Set Download

 1 Remove the spacer ring from the shaft of the reduction gear unit. The spacer ring is coated with sealant.

 

  2. Remove the level gauge and pipe from the hydraulic motor housing, plug the Panasonic and drain the gear oil.  

 

3 Loosen the bolts and separate the motor and reduction device.  

 

4 Remove the No. 1 sun gear. 

 

 5. Install the lifting eye on the No. 1 planet gear carrier and lift it out together with the No. 1 planet gear. 

 

2023 CAT ET 2023A 2023C & 2019C Full Service Download and Installation Service 

 6. Disassemble the No. 1 planetary carrier assembly. Remove the retaining ring. Remove the side plate, No. 1 planetary gear, needle bearing and two sliding plates. But do not remove the No. 1 pin, No. 1 planet carrier and spring pin. 

 

 7Remove the second sun gear and the retaining ring if necessary. 

 

 8. Remove the No. 1 ring gear and mark it for assembly.

 

  9 Loosen the bolts and remove the housing.  

 

10 Install the lifting eye screw on the shaft and remove the shaft assembly. When disassembling the shaft assembly, remember to mark the locating pins for ease of assembly. 

 

 11 After marking the outside of the No. 2 ring gear and the front housing, remove the No. 2 ring gear from the front housing. 

 

 Caterpillar 18 Digits Factory Password Calculator One-Time Calculate Service

 12 Remove the oil seal from the front housing. 

 

 13 Use special tools to remove the bearing. 

 

 14 Place the remaining parts on the workbench with the shaft facing upwards, and use the pin removal jig to hit the key hard to remove the pin. 

 

 15 Remove the remaining spring pins from the shaft. 

 

 16Remove the No. 2 planetary gear and push washer. 

 

 17 Since the thrust journal is installed into the shaft, if it needs to be replaced, it can be removed with the jacking screw. 

 

 18It is not necessary to remove the bearing.


312D2 and 313D2 Excavators, Machine Systems Duo-Cone Universal Floating Seal - Installation

  This article describes the 312D2 and 313D2 excavators, machine systems Duo-Cone Universal Floating Seal - Installation Caterpillar ET2024...