(1) There is a fault code.
(2) The connector is unreliable and incorrect.
(3) Operating in cold mode.
(4) The signal from the low idle position to the high idle position is unstable.
(5) The fuel injection drive pressure is abnormal.
(6) The fuel injector does not work.
(7) The fuel system is faulty.
(8) The air intake and exhaust systems are faulty.
2023 CAT ET 2023A 2023C & 2019C Full Service Download and Installation Service
2. Troubleshooting
If the fault occurs only under certain operating conditions (high idle speed, full load, high engine
operating temperature, etc.), then test the diesel engine under these conditions.
(1) Check whether there is a fault code on the ET. Troubleshoot and troubleshoot all fault codes before
continuing with this procedure.
(2) Check whether the ECM connectors J1/P1 and J2/P2 and the injector connector are installed
correctly. Please refer to Section 11.4 of this chapter.
Caterpillar CAT Factory Password Calculator Generator 10 Digits VM Version
(3) Use ET to check whether the diesel engine has left the cold mode. Operating in cold mode can
cause the diesel engine to run erratically and limit diesel engine power.
(4) Monitor the throttling signal on ET. Check whether the throttle signal is stable from the low idle position to the high idle position.
(5) Check the injection drive pressure, please refer to Section 6.3.
(6) Check the fuel system, please refer to Section 6.4 of this section.
(7) Check the air filter clogging indicator. Clean or replace clogged air filter.
(8) Check whether the air intake and exhaust systems are blocked and/or leaking.
